Autor Tema: Documentación. Electrónica analógica  (Leído 11566 veces)

0 Usuarios y 1 Visitante están viendo este tema.


  • Moderador Global
  • ****
  • Mensajes: 294
Documentación. Electrónica analógica
« en: 08/Sep/2015, 19:50:26 pm »
Texas Instruments. Analog Engineer’s Pocket Reference.
Componentes discretos, señales analógicas, amplificadores operacionales, circuitos impresos y cableado, sensores, conversores analógico-digitales.

Hans Camenzind. Designing Analog Chips.
Del diseñador del famoso timer NE555.
A comprehensive introduction to CMOS and bipolar analog IC design. The book presumes no prior knowledge of linear design, making it comprehensible to engineers with a non-analog background. The emphasis is on practical design, covering the entire field with hundreds of examples to explain the choices. Concepts are presented following the history of their discovery.
1. Devices Semiconductors, The Bipolar Transistor, The Integrated Circuit, Integrated NPN Transistors, The Case of the Lateral PNP Transistor, CMOS Transistors, The Substrate PNP Transistor, Diodes, Zener Diodes, Resistors, Capacitors, CMOS vs. Bipolar.
2. Simulation, DC Analysis, AC Analysis, Transient Analysis, Variations, Models, Diode Model, Bipolar Transistor Model, Model for the Lateral PNP Transistor, MOS Transistor Models, Resistor Models, Models for Capacitors. 3. Current Mirrors. 4. Differential Pairs. 5. Current Sources. 6. Time Out: Analog Measures, dB, RMS, Noise, Fourier Analysis, Distortion, Frequency Compensation. 7. Bandgap References. 8. Op Amps . 9. Comparators 10. Transimpedance Amplifiers 11. Timers and Oscillators . 12. Phase-Locked Loops . 13. Filters . 14. Power, Linear Regulators, Low Drop-Out Regulators, Switching Regulators, Linear Power Amplifiers, Switching Power Amplifiers. 15. A to D and D to A, The Delta-Sigma Converter. 16. Odds and Ends, Gilbert Cell, Multipliers, Peak Detectors, Rectifiers and Averaging Circuits, Thermometers, Zero-Crossing Detectors. 17. Layout.

« Última modificación: 02/Dic/2015, 16:55:32 pm por Administración del foro »